Victron Energy ORI121236140

The Orion-Tr Smart DC-DC charger is a professional DC to DC adaptive 3-stage charger with built-in Bluetooth.

For use in dual battery systems in vehicles or on boats where the (smart) alternator and the start battery are used to charge the service battery. The unit can be monitored and programmed via Bluetooth and can be remotely controlled via a remote on/off switch and has an engine running detection mechanism.

The Orion Tr-Smart charger can be used in 12V or 24V systems and is suitable for both lead acid and lithium batteries. Models are available up to 400W and unlimited multiple units can be connected in parallel to increase output power.

Suitable for high temperatures up to 55°C with a full rated output up to 40°C


Features

Bluetooth Smart enabled

Any Bluetooth enabled smart phone, tablet or other device can be used to monitor, to change settings and to update the charger when new software features become available.


Fully programmable

- Battery charge algorithm (configurable) or fixed output.

- Smart alternator compatibility: engine running detection mechanism.


Adaptive 3-stage charge algorithm: bulk – absorption – float

- For lead acid batteries it is important that during shallow discharges the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged.

- For lithium batteries absorption time is fixed, default 2 hours.

- Alternatively, a fixed output voltage can be chosen.


Remote on-off

A remote on/off switch or relay contact can be connected to a two-pole connector. Alternatively, the H terminal (right) of the two-pole connector can be switched to battery plus, or the L terminal (left) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example).


All models are short circuit proof and can be paralleled to increase output current

An unlimited number of units can be connected in parallel.


High temperature protected

The output current will reduce at high ambient temperature.


IP43 protection

When installed with the screw terminals oriented downwards.


Screw terminals

No special tools needed for installation.


Input fuse (not replaceable)


Technical Specification


Input voltage range

10-17V

Under voltage shut down

7V

Under voltage restart

7,5V

Nominal output voltage

12,2V

Output voltage adjust range

10-15V

Output voltage tolerance

+/- 0,2V

Output noise

2mV rms

Cont. output current at nominal output voltage and 40°C

30A

Maximum output current (10 s) at nominal output voltage minus 20%

40A

Short circuit output current

60A

Cont. output power at 25°C

430W

Cont. output power at 40°C

360W

Efficiency

87%

Off load current

< 80mA

Galvanic isolation

200V dc between input, output and case

Operating temperature range

-20 to +55°C (derate 3% per °C above 40°C)

Humidity

Max. 95% non-condensing

DC connection

Screw terminals

Maximum cable cross-section

16 mm² (AWG6)

Height

130 mm

Width

186 mm

Depth

80 mm

Weight

1.8 Kg

Warranty

5 Years


Please lick on this link below for more information on this product



Product Data Sheet


Installation Guide Manual

The Blue Smart IP22 BPC122042022 Charger is the new professional battery charger with built-in bluetooth.

The Blue Smart IP22 Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans.

The battery is charged, smartly... to perfect condition

The seven-step charging algorithm gets the best out of your battery.

The charger gives the battery the power it needs, maintains its health, ensures better performance... and a longer life.

Recovery of deeply-discharged 'dead' batteries

Unlike other brands, the Blue Smart IP22 Charger will attempt to recharge a deeply-discharged battery by force-feeding it with a low current.

Normal charging will then be resumed as soon as there is sufficient voltage across the battery terminals.

Check the status of your battery remotely

The Blue Smart IP22 is equipped with built-in Bluetooth, so the status of the charger and the battery can be checked on a smartphone, tablet or laptop.

All settings of the charger can be configured with the VictronConnect app.


Specification

Dimensions (mm)235 x 108 x 65
IP RatingIP22
Output1 Output
SKUBPC122042022
Voltage12V
Weight (kgs)

1.3

Supplied with standard UK 3 pin plug + approx 1.5mtrs flex


Top quality campervan wiring kit supplied with everything needed to charge a leisure battery using the very popular Victron Energy Orion TR smart battery to battery charger and the IP22 mains battery charger



This kit contains the following items

Victron ORI121236140 battery to battery charger + wiring

Leisure Battery Distribution kit + battery isolator

6 or 12 way fuse box kit + wiring 

Mains Hook Up Kit

Victron IP22 12v 20amp Battery Charger + 1m wiring kit 

10m 2mm 25amp Twin Core Cable

 

Simply Select kit length from the drop down menu above for the distance between the main starting battery to the leisure battery location for the battery to battery charger

 


B2BCharging Kit Specifications:

    1 x  Victron Orion 12v 30amp Non isolated Charger

    1-8mtrs 16mm² 110amp Red Cable

    1-8mtrs 16mm² 110amp Black Cable

    5mtrs 1.5mm² 15amp Red Cable ( Option Ignition Switch Feed)

    1-8mtrs 13mm Split Conduit

    1 x Midi Fuse Holders + recommended midi fuses including spares

    1 x Pair 8mm Post Type Battery Terminals

    Crimp Teminals

    Heat Shrink

    Cable Ties

    Screws + Dril Bit


    Leisure Battery Power Distribution kit

    1 x Mega/midi distribution fuse box

    1 x 150amp mega fuse

    1 x 150amp bus bar

    1 x Battery Isolator

    1000mm 25mm² 170amp red battery cable

    1000mm 25mm² 170amp black battery cable

    4 x 25-8 terminal

    2 x 25-6 terminal

    2 x 25-8 erminal

    3 x red + 3 x black heat shrink


    Fuse Box Kit

      1 x 6 or 12 Way Fuse Box

        1m Red 70amp 10mm² Cable

          1m Black 70amp 10mm² Cable

            Crimp Terminals + Heat Shrink

              1 x Midi 60amp fuses

                3 x each 5amp,10amp,15amp & 20amp Blade Fuses

                  24 x 4mm blue insulated ring terminals


                  Mains Hook Up

                  This kit includes everything you need to install a safe and reliable mains system and includes a fully insulated mini-consumer unit with twin miniature circuit breakers with 25 Amp RCD, one 10 Amp and one 6 Amp MCB

                  2x single gang switched white sockets, cables

                  Please select either surface-mounted or flush fit inlet plug above for connects to the site supply.

                  Consumer unit with a 25A, 30mA RCD &amp; 2x single pole MCBs (10A and 6A)

                  2 x single gang switches sockets (surface mounted)

                  Main picture shows surface mounted inlet plug

                  2m of orange 3-core 2.5mm flexible cable (inlet to consumer unit)

                  5m of white 3-core 2.5mm 240V flexible cable (consumer unit to sockets)

                  2m of green/yellow 6mm earth cable + ring terminal (consumer unit earth bonding)

                  Cable clips

                  Installation instructions

                  Consumer unit dims: 200 (H) x 110 (W) x 95 (D) mm


                  Victron IP22 12v 20amp Battery Charger

                  The Blue Smart IP22 BPC122042022 Charger is the new professional battery charger with built-in bluetooth.

                  Dimensions (mm)235 x 108 x 65
                  IP RatingIP22
                  Output1 Output
                  SKUBPC122042022
                  Voltage12V
                  Weight (kgs)

                  1.3

                  Supplied with standard UK 3 pin plug + approx 1.5mtrs flex



                  Write a review

                  Note: HTML is not translated!
                      Bad           Good
                  Captcha

                  Campervan Wiring Kit with Orion TR Smart Battery to battery Charger + Mains Hook Up + IP22 20amp Battery Charger

                  • £576.00

                  • Ex Tax: £480.00

                  Available Options


                  Related Products

                  Flat Twin Core Automotive Cable 2mm 25amp (Thin Wall)

                  Flat Twin Core Automotive Cable 2mm 25amp (Thin Wall)

                  Flat Twin Core Automotive Cable 2mm 25amp (Thin Wall) Top quality British made Twin Core Cable ..

                  £1.80 Ex Tax: £1.50

                  Digital LCD Multimeter Voltmeter Ammeter OHM AC DC Circuit Tester Buzzer

                  Digital LCD Multimeter Voltmeter Ammeter OHM AC DC Circuit Tester Buzzer

                  Digital LCD Multimeter Voltmeter Ammeter OHM AC DC Circuit Tester Buzzer 3.5 Digit Handheld Palm ..

                  £17.34 Ex Tax: £14.45

                  USB Power Socket + Standard 20A Power Socket + Volt Meter Panel + Switch

                  USB Power Socket + Standard 20A Power Socket + Volt Meter Panel + Switch

                  USB Power Socket + Standard 20A Power Socket + Volt Meter Panel + Switch Dual recessed power sock..

                  £17.50 Ex Tax: £14.58

                  Out Of Stock
                  25mtr Mains Hookup Lead

                  25mtr Mains Hookup Lead

                  25M SITE EXTENSION LEAD Caravan site extension lead with 25m cable 100% copper (3 core 2...

                  £34.84 Ex Tax: £29.03